DEWALT D100P-TB Tie-Back Personal SRL, 9 ft
The DEWALT D100P-TB DXFP240511-009 is a single personal self-retracting lifeline with 9 ft of Dyneema webbing and a steel tie-back snap hook. It is designed for permitted wrap-around anchorage connections using the manufacturer’s tie-back procedure. A high-impact polymer housing and recessed labels support routine handling and inspection.
DEWALT / DXFP240511-009
Single personal tie-back SRL
9 ft
Dyneema webbing
5,000 lb, manufacturer listed
ANSI Z359.14-2021 Class 1
130–310 lb, including equipment
Key Features
- Purpose-designed steel tie-back snap hook
- Harness carabiner with 3,600 lb gate rating
- Single retracting web lifeline
- 9 ft working length before tie-back configuration allowances
Common Uses & Applications
- Approved wrap-around anchorage applications
- Construction and maintenance with suitable overhead structures
- Personal fall-arrest systems requiring a tie-back connector
Selection and System Compatibility
Use only the approved tie-back method and a compatible structure. The manual describes the protected webbing wrapping around the anchorage, with the tie-back hook secured around the webbing. Avoid sharp or abrasive surfaces. Allow for the length used in the wrap; the 9 ft working length is not a promise of 9 ft reach after installation. This single-leg unit does not provide twin-leg transfer capability.
Manufacturer-Listed Standards
DFP lists ANSI Z359.14-2021 Class 1 Personal, with 130–310 lb ANSI and 130–420 lb OSHA-use ranges under its instructions. Tie-back capability does not establish leading-edge or foot-level approval. Keep anchorage at or above dorsal D-ring height and follow the manual’s clearance and loading restrictions.
Inspection and Safety
Read the instructions before use. Inspect equipment before each use, remove damaged or fall-loaded equipment from service, and arrange prompt rescue. Follow applicable OSHA construction fall-protection requirements or general-industry personal fall-protection requirements.
Manufacturer Documents
FAQ
Does tie-back mean leading-edge rated?
No. This is a Class 1 tie-back SRL; the approved connection method does not establish leading-edge performance.
Can I use any snap hook for a tie-back connection?
No. Only equipment specifically designed and instructed for tie-back may be used that way.
