DEWALT Reusable Concrete Fall-Protection Anchor
The DEWALT DXFP845101 reusable concrete anchor provides a removable connection point for approved concrete fall-protection applications. Its expanding end fits a properly prepared 3/4-inch mounting hole. A spring-loaded trigger and retractor cables allow removal and relocation after use, subject to inspection and the manufacturer’s installation requirements.
DEWALT / DXFP845101
DXFP845101
Concrete anchorage
3/4 inch
Galvanized steel and aluminum
Up to 310 lb
Reusable expanding anchor
Key Features
- Removable design for relocation between approved locations
- Spring-tensioned release mechanism
- Horizontal, vertical and overhead applications as permitted by instructions
Common Uses & Applications
- Concrete construction fall-protection planning
- Industrial maintenance on approved concrete structures
- Temporary anchorage where installation conditions can be verified
Selection and System Compatibility
The hole diameter alone does not determine whether an installation is suitable. Verify concrete strength, slab thickness, hole depth, edge distance, cleaning and loading direction using the model-specific manual. A qualified assessment of the supporting structure is essential. Do not use this anchor as a material-lifting point or assume that any drilled concrete hole is acceptable.
Manufacturer-Listed Standards
DFP’s declaration identifies ANSI Z359.18-2017 Type A; the current manual also lists CAN/CSA Z259.15-22. Product conformance does not establish the capacity of the structure or an incorrectly installed anchor. Follow the supplied label and approved installation instructions.
Inspection and Safety
Read the instructions before use. Inspect equipment before each use, remove damaged or fall-loaded equipment from service, and arrange prompt rescue. Follow applicable OSHA construction fall-protection requirements or general-industry personal fall-protection requirements.
Manufacturer Documents
FAQ
Can the anchor be reused?
Yes, subject to the manufacturer’s removal procedure, inspection and approved reinstallation conditions.
Is the mounting hole the only installation requirement?
No. Concrete condition, geometry, preparation and loading restrictions must also meet the manual.
