MSA V-Gard American Flag Hard Hat for Industrial Work
The MSA V-Gard American Flag hard hat features the American Flag with Two Eagles design from the American Freedom Series. Model 10052947 combines a decorated polyethylene shell with a Fas-Trac III ratchet suspension for construction, manufacturing and maintenance work. Its cap-style profile provides a front brim, while accessory slots allow compatible MSA equipment to be fitted when the job requires additional protection.
MSA / 10052947
S10052947
Polyethylene with thermoformed graphics
Slotted protective cap
Type I, Class E
Fas-Trac III ratchet
Hat sizes 6½–8
ANSI/ISEA Z89.1-2014; CAN/CSA Z94.1-2015
Key Features
- American flag and dual-eagle graphics distinguish this model from other Freedom Series designs.
- Ratchet adjustment helps establish a secure, comfortable fit.
- Nape adjustments allow the suspension to sit appropriately at the back of the head.
- Accessory slots accommodate compatible equipment approved by MSA.
Common Uses
- Construction sites requiring Type I head protection.
- Manufacturing and production facilities.
- Industrial repair and maintenance departments.
- General plant work with identified overhead hazards.
Choosing Head Protection for the Job
Type I identifies top-impact protection. This cap should not replace a Type II helmet where the hazard assessment requires lateral-impact protection. Class E describes the helmet’s electrical classification; it does not authorize energized work or replace other required electrical protective equipment. The decorative graphics do not establish a high-visibility rating.
Under OSHA 29 CFR 1910.135, employers must provide appropriate protective helmets where falling objects present a head-injury risk, and electrical protection where exposed conductors could contact the head. OSHA 29 CFR 1926.100 addresses head protection in construction. Selection must match the actual task and exposure.
Fit, Inspection and Accessories
Adjust the suspension before starting work and inspect both shell and suspension for damage or deterioration. Follow MSA’s replacement instructions after an impact. Use compatible replacement parts and verify accessory compatibility before adding face or hearing protection. Do not drill the shell or make unapproved modifications.
Manufacturer Documentation
MSA Fas-Trac III and Freedom Series bulletin (PDF) lists American Flag with Two Eagles model 10052947 on page 6. This manufacturer bulletin covers multiple helmets and includes earlier standards editions. The standards above follow MSA’s current model-specific listing; confirm the markings and instructions supplied with your helmet.
FAQ
Which American Flag design is this?
Model 10052947 is the American Flag with Two Eagles slotted cap. It is different from the Stars and Stripes and single American Eagle designs.
Can this hard hat be worn backward?
Only when the helmet carries the reverse-donning marking and the suspension is installed as MSA instructs. Do not assume every helmet configuration allows reverse wear.
Does it include a face shield or earmuffs?
This listing is for the hard hat. Select any additional protective equipment separately and verify compatibility with MSA.
